Leak sealer for Hot Tubs and Spas. Seals minor leaks and cracks in hot tubs, usually stops leaks in 24 hours.
Directions for Use:
- Turn the Pump off. Remove cartridge or filter grids to prevent product from passing through the filtration system.
- If the leak location is unknown, add the recommended dosage to the skimmer area. If you are sure of the leak's location, pour the recommended dosage directly into the water at the leak.
- After 30 minutes following application, turn the pump on and allow to run for at least 8 hours.
- Check the spa to see if it is still losing water. A second application may be required.
- Replace filter grids or cartridges after 24 hours then resume normal filtration.
- Re enter spa after 24 hours
Dosage Amount:
- 1,900 L Add 30ml
- 2,850 L Add 45ml
- 3,800 L Add 60ml
Important Notes:
- Remove cartridges to prevent the product from passing throughthe filtration system.
- Possible that fine fountain jets may block when this product is applied.
